Install Wheel Kit - Generac Portable Products 1313-1 Owner's Manual

INSTALL WHEEL KIT

IMPORTANT: This wheel kit is not intended for
over-the-road use.
To install your wheel kit you need the following tools:
• Two 13mm box, open end, or socket wrenches
Install Wheel Kit as follows:
• Place the bottom of the generator cradle on a flat, even
surface. Temporarily place unit on blocks to ease
assembly.
• Slide axle through both axle mounting brackets on cradle
frame, as shown.
• Slide a wheel over the axle.
Figure 2 — Install Wheel Kit
Cap Screw
Handle Assembly
Hex nut
Mounting Leg
Use Existing Fasteners
Generac Portable Products 3,500 Watt Generator
NOTE: Be sure to install both wheels with the air
pressure valve on the outboard side.
• Retain wheel on axle with the retaining pin.. You may add
• Repeat step 3 and 4 to secure second wheel.
• Remove the existing hardware from the vibration mounts
• Remove the temporary blocks.
• Center the handle bracket on generator frame at control
• Attach handle bracket with two cap screws and two hex
5
the flat washer if desired.
with 13mm wrench. Use the same hardware to attach
the mounting leg.
panel end of cradle.
nuts. Use two 13 mm wrenches to tighten hardware.
Jam Nut
Wheel
Flat Washer
Retaining Pin