Install Wheel Kit - Generac Portable Products 5500XL Owner's Manual

INSTALL WHEEL KIT

To install your wheel kit you need the following:
• Socket wrench with 1/2" or 13mm socket.
Install Wheel Kit as follows: (See Figure 2)
• Place the generator on a hard flat surface.
• Place temporary blocks under unit to ease assembly.
• Slide the axle through the holes in the brackets provided
on the generator cradle and then add the two spacers on
each protruding end of the axle.
• Slide on the wheels on each end of the axle and secure
with washer and retaining pin.
Figure 2 — Assemble Wheel Kit
Hex Head
Capscrew,
M8 x 45mm
Lock Nut, M8
Generac Portable Products 5500XL Generator
Handle
Support Leg
Vibration Mount
Flat Washer
NOTE: Make sure the wheel air inflation valves are facing
outward.
• Attach the vibration mounts to the support leg with M8
x 30mm capscrews, M8 washers and lock nuts.
• Attach the support leg with two M8 x 20mm capscrews
and two lock nuts. Remove temporary blocks.
• Attach the handle with four M8 x 45mm capscrews and
four lock nuts in the location shown.
Hex Head
Capscrew,
M8 x 20mm
Lock Nut, M8
Hex Head
Capscrew,
M8 x 30mm
5
Axle
Wheel
Spacer
Wheel
Flat Washer
5/8"
Retaining Pin