GE EER2000 Owner's Manual page 25

ge.com
Oven Shelves
All oven shelves may be cleaned by hand
Mill an abrasNe cleaner or steel wool.
After cleaning, rinse file sheh'es Mill
clean water and d_T Mill a clean clod1.
Gray porcelMn-coated oven sheNes may
remMn in file oven during file self-
cleaning cycle Mdlout being damaged.
The shiny, sih'er-colored oven sheh'es
may remMn in file oven during file self-
cleaning cycle, but flley Mll lose dleir
luster and become hard to slide.
It will be necessary to g_etkse M1 oven
shelf side edges Mill a light coating of
vegetable oil after cleaning them by hand
or in the oven. This will help maintain
the ease of sliding the sheh'es in and
out of the oven.
il Stopguide
Storage Drawer Removal
Toremovethe drawer:
[_ Pull tile drawer out until it stops.
[_ I,ift tile flont of tile drawer until the
stops clear the guides.
[_] Remove tile draweL
Toreplacethedrawer:
[_ Place tile drawer rails on tile guides.
[_ Push tile drawer back until it stops.
[_ Lift tile flont of tile drawer and push
back until tile stops clear tlle guides.
[] Lower tlle flont of tile drawer and
push back until it closes.
Wire cover holder.
Oven Light Replacement
CAUTION: Before replacing your oven
light bulb, disconnect the electrical
power to the range at the main fuse or
circu# breaker panel
Be sure to let tlle light cover and bulb
cool completel):
Toremove the cover:
Hold a hand under tile cover so it
r
doesnt fall when _eleased. _(_ith
fingers of the same hand, firmly
push back tlle wire cover holdeL
Lift off tile coveL
Do not removeany screws to remove the cover.
[_] Replace bulb wkh a 404vatt
appliance bulb.
Toreplace the cover:
[77 Place it into groove of tile light
receptacle. Pull wire foIward to
the cenmr of the cover until it
snaps into place.
[_] Connect electrical power to
the range.
Oven Heating Elements
Donotcleanthebakeelementor thebroil
element. A nysoilwill bumoff whenthe
elements areheated.
To clean the oven flooI, gently lift
tile bake element. Clean with warn1
soapy wateL
25