Troubleshooting - Briggs & Stratton BSP5500L Owner's Manual

TROUBLESHOOTING
Problem
Engine is running, but noAC
output is available.
Cause
I. Circuit breaker is open.
2. Poor connection or defective cord
set,
3. Connected device is bad.
Solution
I. Reset circuit breaker.
2. Check and repair.
4. Fault in generator.
I. Short circuit in a connected load.
Engine runs good but bogs down 2. Generator is overloaded.
when loads are connected. 3. Shorted generator circuit.
I. Fuel valve is in the "Closed"
Engine will not start; or starts and position.
runs rough.
2. Low oil level.
Engine shuts down during Out of gasoline.
operation.
Engine lacks power. Load is too high. See "Don't Overload Generator".
3. Connect another device that is in
good condition.
4. Contact Briggs and Stratton
service facility.
I. Disconnect shorted electrical load.
2. See "Don't Overload Generator".
3. Contact Briggs and Stratton
service facility.
I. Turn fuel valve to the "Open"
position.
2. Fill crankcase to proper level.
Fill fuel tank.