Lift-Off Oven Door; Shelves - GE JMS08 Owner's Manual

Electric drop-in ranges
Hide thumbs Also See for JMS08:
Table of Contents

Advertisement

ge.com
Oven Shelves
Clean
the
oven
sheh'es
with
an abrasive
cleanser or steel wool.
AtYer cleaning, dnse file sheh'es wifll
clean water and d_T wifll a clean cloth.
Lift the door straight up and off the
hinges.
Lift-Off Oven Door
The oven door is removable for cleaning.
Onnotlift thedoorbythehandle.
Toremove the door,open it m fl_e broil
stop position. Grasp fimdy on each side
and lift the door smdght up and off the
binges.
Donotplacehandsbetweenthehingeandthe
ovendoorframe.
Toreplace the door, make sure the hinges
are in file broil stop position. Position file
slots in the bottom of file door squarely
over the binges and slowly lower it over
both binges.
Toclean theinsideof thedoor:
i{i:i Soap and water will normally do file
job. Hem T spattering or spillovers may
require cleaning with a mild abrasive
cleaneL Soapy, wet metal pads may also
be used.
Donotallowfoodspills with a highsugaror acid
content(such astomatoes, sauerkraut, fruitjuices
or pie filling)to remainon thesurface. T hey may
cause a duffspotevenafiercleaning
@
@
If necessary, you may use an oven
cleaneL Follow the package directions.
Clean the inside of file oven window
with a mild non-scratching
cleaner and
a damp cloth.
Tocleanthe outsideofthedoor:
@
@
Use soap and water m thorougldy
clean the top, sides and flont of the
oven dooL Rinse well. You may also
use a glass cleaner
to clean file glass
on file outside
of file dooL Do not let
water drip into file vent openings.
Spillage
of marinades,
fluitjuices,
tomato
sauces and basting
mam_iMs
containing
acids may cause
discoloration
and should
be wiped
up
immediately.
When
surface
is cool,
clean and rinse.
i_ Do not use oven cleaners, cleaning
powders or harsh abrasives on file
outside of the dooL
Wire cover holder.
Oven Light Replacement
CAUTION: Before replacing your oven
light bulb, disconnect the electrical
power to the range at the main fuse or
circu# breaker panel
Be sure m let the light cover and bulb
cool completely:
Toremove the cover:
%
Hold a hand under file cover so it
doesn't fidl when released. With
fingers of the s_une hand, firmly
push back the wire cover bolder
I,ift off"the coveL
Do not remove any screws to remove
the cover.
Replace bulb with a 40-watt
household appliance bulb.
Toreplace the cover:
%
Place it into groove of file light
receptacle. Pull Mre fon,wud m file
cenmr of the cover until it snaps
into place.
Connect
elecuical
power to the
range.
11

Advertisement

Table of Contents
loading

Table of Contents