Connecting A Dvd Player - Aiwa NSX-MA845 Operating Instructions Manual

OTHER CONNECTIONS
--5.1CH INPUT
-- VIDEO/AUX
--Me
-- LINE OUT
oeo
el
2-
(OPTICAL)
Refer to the operating instructions of the connected equipment
for details.
• The connecting cords are not supplied. Obtain the necessary
connecting cords.
• Consult your local Aiwa dealer for optional equipment.
VIDEO/AUX JACKS
This unit can input analog sound signals through these jacks.
Use a cable with RCA phone plugs to connect audio equipment
(turntables, LD players, MD players, VCRs, TV, etc.).
Connect the red plug to the VIDEO/AUX R jack, and the white
plug to the VIDEO/AUX L jack.
When connecting a turntable
Use an Aiwa turntableequipped with a built-in equalizer amplifier.
MD JACKS
This jack is recommended to connect with an MD player.
Use a cable with RCA phone plugs.
Connect the red plug to the MD R jack, and the white plug to the
MD L jack.
LINE OUT JACKS
This unit can output analog sound signal through these jacks.
Use a cable with RCA phone plugsto connect audio equipment
with LINE IN (analog input) jacks.
Connect the red plug of a cable to LINE OUT R jack, and the
white plug to LINE OUT L jack.
Do not connect an equipment to LINE OUT jacks and VIDEO/
AUX jacks simultaneously. Otherwise, noise is generated and
malfunction occurs.
CD DIGITAL OUT (OPTICAL) JACK
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (DAT
deck, MD recorder, etc.).
Remove the dust cap _) from the CD DIGITAL OUT (OPTICAL)
jack. Then, connect an optical cable plug to the CD DIGITAL
OUT (OPTICAL) jack.
When the CD DIGITAL OUT (OPTICAL) Jack Is not being
used
5.1 CH INPUT JACKS
This unitcan inputsound signalsfrom the audio equipment (DVD
player, LD player, etc.) that contains a Dolby Digital decoder with
the 5.1 ch output terminals. Refer to "CONNECTING A DVD
PLAYER" on page 31.
POWER--
| I rl ]- "1 _
. Jtiiiilliili
==== 0 0 0 c:c::_',
v
VIDEO/AUX/5,1CH
--MD
To play equipment connected to VIDEO/AUX]5.1CH jacks or MD
jacks proceed as follows.
1 PressVIDEO/AUX/5.1CH or MD.
To clay the eauioment connected to VIDEO/AUX, press
VIDEO/AUX/5.t CH. "VIDEO" appears on the display.
To olav the eauiDment connected to MD, press MD. "MD"
appears on the display.
2 Play the connected equipment.
To change a source name in the display
When VIDEO/AUX/5.1CH is pressed, "VIDEO" is displayed
initially. It can be changed to "AUX" or "TV".
With the power on, press POWER while pressing VIDEO/AUX/
5,1CH.
Repeat the procedure to select one of the names.
To adjust the sound level of the external source
When the sound level of the external source is much higher or
much lower than that of other functionsources, adjustit as follows.
1 Press VIDEO/AUX/5.1CH or MD and play the equipment.
2 Press <t<1 or _ sothat the sound level becomes the same
as that of other function sources.
During recording, the sound level can not be adjusted.