Connecting A Dvd Player - Aiwa CX-NHMT75 Operating Instructions Manual

CONNECTING A DVD PLAYER

5.1CH INPUT jacks of this unit support the DOLBY DIGITAL
SURROUND system.
Connect a DVD player with 5.1CH output jacks to this unit using
cables with RCA phono plugs as follows;
This unit's jack DVD player's jack
5.1CH SUB WOOFER 5.1CH OUTPUT SUB WOOFER, etc.
5.1CH CENTER 5.1CH OUTPUT CENTER, etc.
5.1CH SURROUND (L,R) 5.1CH OUTPUT SURROUND (L,R), etc.
5.1CH FRONT (L,R) 5.1CH OUTPUT FRONT (L,R), etc.
VIDEO/AUX (L,R) LINE OUT (L, R), etc.
• If the DVD is not connected to VIDEO/AUX jack of this unit;
- the spectrum analyzer does not show the sound level of the
DVD player.
- the sound from the connected DVD player cannot be recorded.
To remove these limitations, connect the LINE OUT jacks of the
DVD player to VIDEO/AUX jacks of this unit besides connecting
to 5.1CH INPUT jacks. The signals through VIDEO/AUX jacks
enable the spectrum analyzer to work and the recording to be
done.
Refer also to the operating instructions of the DVD player.
• DOLBY DIGITAL SURROUND sound cannot be recorded in
any way.
(See "NOTE", below.)
LISTENING TO
SURROUND SOUND
When a DVD player is connected to the 5.1CH INPUT jacks of
this unit, you can listen to DOLBY DIGITAL SURROUND sound,
which enables you to enjoy theater-quality sound in your home.
1 Press VIDEO/AUX/5.1CH repeatedly until "5.1 ch
IN" is displayed.
2 Start playing DOLBY DIGITAL SURROUND sound
on the DVD player.
• The DOLBY PRO LOGIC, BBE and the DSP SURROUND are
automatically canceled when the 5.1 CH is selected.
• Make sure the software played back with the connected DVD
player support the DOLBY DIGITAL SURROUND.
• The function is changed from the 5.1 CH to the VIDEO when;
- the headphones are plugged in.
- the MIC or ECHO level is changed.
- the DSP SURROUND system, the DOLBY PRO LOGIC or
the Karaoke function is turned on.
To adjust the sound levels of the center and surround
speakers in DOLBY DIGITAL SURROUND
1 Press VIDEO/AUX/5.1CH repeatedly until "5.1 ch IN" is
displayed.
2 Press MANUAL SELECT repeatedly.
Speaker names appear in turn as follows;
L/R (Speaker balance)
S-W: Sub woofer
S-R: Right surround speaker
3 Press f DOWN or g UP to adjust the sound level while
"CEN", "S-L", "S-R" or "S-W" is displayed.
Each level can be adjusted between -8dB and +7dB.
4 Repeat steps 2 and 3 to adjust each speaker's sound level.
If the surround speakers or the center speaker level of the DOLBY
DIGITAL SURROUND is changed, that of the DSP SURROUND
system (page 11) and the DOLBY PRO LOGIC (page 21) is also
changed.
DOLBY DIGITAL
CEN: Center speaker
S-L: Left surround speaker
29
ENGLISH
En