When installing:
• Ensure that the DC-in connector and the fan connector are attached to the system board firmly.
• Do not press the top of the fan cover and the fan hub
• Before you attach the fan assembly to the computer, apply thermal grease, at an amount of 0.2 grams,
on the part marked
a
can cause a thermal fan problem due to imperfect contact with a component. You need to peel the
thin film off from the rubber
2010 LCD front bezel
For access, remove this FRU:
•
"1010 Battery pack" on page 56
as in the following illustration. Either too much or too less application of grease
b
.
.
Chapter 9
Removing or replacing a FRU
85