Lenovo ThinkPad X230 Hardware Maintenance Manual page 79

When installing: Plug the red cable into the main connector, and the blue cable into the auxiliary connector
on the card.
If the computer you are servicing is a wireless WAN-ready model and does not have a wireless WAN card,
route the antenna cables and secure them with tape as shown in the following illustration.
Removal steps of mSATA solid-state drive
Note: The computer comes with either a PCI Express Mini Card for wireless WAN or an mSATA solid-state
drive. If the computer is equipped with an mSATA solid-state drive, it is installed in the wireless WAN
card slot.
Attention:
• Do not drop the drive or apply any physical shock to it. The drive is sensitive to physical shock. Improper
handling can cause damage and permanent loss of data.
• Before removing the drive, have the user make a backup copy of all the information on it if possible.
• Never remove the drive while the computer is operating or in suspend mode.
• After installation of a new drive, go to http://www.lenovo.com/support for instructions on configuring the
drive.
.
Chapter 9 Removing or replacing a FRU
73