Screen Displays - EverFocus PowerPlex EDR-920 Installation & Operation Manual

1.6 SCREEN DISPLAYS

Here's an overview of the screen displays appearing on the MAIN monitor:
Channel display: shows the selected video channel's description
1
Event: Event display, may be channel-related or global
2
Channel-related types of event:
Alarm: Display of an alarm triggered by alarm input contact
A
Motion: Motion detection of the respective camera
M
Video loss: Video signal loss of the respective camera
V
Sequence: Sequential operation of the respective video channel
S
*
- In multiscreen display, this icon indicates the channel selected for sequential
display. Selection via SELECT key. Upon sequence activation, the "*" icon is replaced
by
S
Global types of event:
OT OT - Over Temperature HDD: Alarm message upon HDD over temperature,
displayed in red on all video channels. The device should immediately be switched off.
In case the „FAN" (fan damage) message occured previously, contact the technical
service for trouble shooting. If the fan works properly, check the device's position as
regard to ambient temperature (max. 40°C, fan must not be covered, ensure the
sufficient ventilation if device is installed in cabinet or rack).
12
1. Channel display
2. Event (here: video loss)
3. Display selection
4. Playback status
5. Recording status