Advertisement
SECTION 3: ASSEMBLY
NOTE: References to LEFT, RIGHT , FRONT and
REAR of the tractor are from the operator's position.
•
Before assembly, place the tractor on a firm, level
surface, disengage the PTO, stop the tractor
engine and set the parking brake.
Mounting Bracket Assembly
Tractors equipped with Shoulder Bolt A
NOTE: For convenience, pivot the seat forward and
leave it in that position until the grass collector is fully
mounted and assembled.
•
Remove the hairpin clip and clevis pin from the rear
of the mounting bracket assembly.
•
Position the hooked ends of the bracket assembly
to the outside of the hitch plate and over the
shoulder bolts. See Figure 3.
Shoulder Bolt A
Figure 3
•
Reinsert the clevis pin through the aligned holes
(Figure 3) in both the bracket assembly and the
hitch plate and secure with the hairpin clip. Refer to
Figure 5.
There are two holes in the clevis pin. Be
IMPORTANT:
sure to insert the hairpin clip in the upper hole to
properly secure the bracket assembly to the hitch plate.
Tractors without Shoulder Bolt A
•
Insert shoulder bolt (C in Figure 2) through a bell
washer (B in Figure 2) and insert the bolt through
the support bracket (F in Figure 2). Secure with nut
(A in Figure 2). See Figure 4.
•
Place one support bracket on each side of the
tractor frame aligning the two smaller holes on the
bracket with corresponding holes on the tractor
frame. See Figure 4. Secure with self-tapping
screw (E in Figure 2).
•
Remove the hairpin clip and clevis pin from the rear
of the mounting bracket assembly.
(refer to Figure 3)
Mounting
Bracket
7
•
Position the hooked ends of the mounting bracket
assembly to the outside of the hitch plate and over
the shoulder bolts just installed on both sides of the
tractor frame. Follow arrows in Figure 4.
•
Align the hole at the rear of the mounting bracket
assembly to the hole on the hitch plate and re-insert
the clevis pin through these two holes. Secure with
the hairpin clip removed earlier.
Be sure to insert the hairpin clip in the
IMPORTANT:
upper hole of the clevis pin.
Mounting
Support Bracket
Bracket
Nut
Hitch Plate
Figure 4
Attaching Grasscatcher Cover and Bags
•
Place the grasscatcher cover assembly's support
tube in position on the rear of unit by sliding the
support tube down through the center hole in the
mounting bracket assembly. See Figure 5.
Clevis
Pin
Hairpin
Clip
NOTE:
Grasscatcher cover not shown here for clarity
Figure 5
Self-Tapping
Screw
Shoulder
Bolt
Bell
Washer
Support
Tube
Mounting
Bracket
Hitch Plate
Advertisement
