Advertisement
Assembly & Installation
NOTE: References to left, right, front and rear of the tractor are
from the operator's position, unless otherwise stated.
disengage the PTO, stop the tractor engine and set the
parking brake.
Assemble Mounting Brackets
To assemble the bagger mounting assembly, locate the
mounting assembly parts, as shown in Figure 4-1, and follow
these steps:
1.
Attach the two hitch side brackets to the rear attachment
bracket using four 710-0276 carriage bolts and 712-04063
4-1.
Note: When assembling this mounting assembly, it is best to
not fully tighten the bracket at this time. This will facilitate the
mounting process in later steps, which will then require fully
tightening this mounting assembly.
Mount Assembly on Tractor
Install mounting assembly on tractor as follows:
1.
Slide the mounting bracket assembly along the frame rails
of the tractor until the hooks in the mounting brackets
align under the shoulder bolts on your tractor, as seen in
Figure 4-2.
Note: Remove rear tube bumper if equipped.
8
Figure 4-1
Figure 4-2
2.
Secure the mounting bracket assembly to the tractor using
Figure 4-3
3.
Tighten all of the hardware installed at this time.
4.
Install the upright support bracket onto the mounting
assembly on the tractor by hooking it over the mounting
assembly as shown in Figure 4-4.
4
Advertisement
