Installation - Alpine CDM-7874R Owner's Manual

Installation

1
Bracket
Dashboard
Mounting sleeve
(Included)
No Pressure Here
No Pressure Here
Remove the Detachable Front Panel (refer to
page 4). Slide mounting sleeve from main unit
(see Removal Procedure below). Slide the
mounting sleeve into the dashboard.
2
Metal Mounting Strap
Hex Nut (M5)
When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of the CDM-
7874R/CDM-7872R/CDM-7871R/CDE-7860R
and put the Rubber Cap on the hex bolt. If your
vehicle does not have the Mounting Support,
reinforce the head unit with the metal mounting
strap (not supplied). Connect all the leads of the
CDM-7874R/CDM-7872R/CDM-7871R/CDE-
7860R according to details described in the
CONNECTIONS section.
NOTE
For the screw ∗, provide a proper screw to the chassis
installing location.
Rubber Cap
(Included)
Hex Bolt
(Included)
CDM-7874R/CDM-7872R/
CDM-7871R/CDE-7860R
Screw
Bolt Stud
∗
CDM-7874R/CDM-7872R/
CDM-7871R/CDE-7860R
3
Slide the CDM-7874R/CDM-7872R/CDM-7871R/
CDE-7860R into the dashboard. When the unit is
in place, make sure the locking pins are fully
seated in the down position. This can be done by
pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will
not accidentally come out from the dashboard.
Install the Detachable Front Panel.
Lock pin
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to
push the locking pins to the "up" position (see
Fig. 3). As each pin is unlocked, gently pull out
on the unit to make sure it does not re-lock
before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Front frame
CDM-7874R/CDM-7872R/
CDM-7871R/CDE-7860R
Screws (M5 × 8)
(Included)
Mounting Bracket
21
-EN