GE CTS18HBSDRWW Owner's Manual And Installation Instructions page 8

About storage drawer and cover removal.
Not all features are on all models.
Drawer and Cover Removal
Drawers can be removed easily by grasping
the sides and lifting up slightly while
pulling drawers past the stop location.
Full-Width Drawer with Plastic Cover
To remove the cover, lift it off its supports,
[)tall it forward, tilt it and rake it out.
Twin Drawers with Glass Cover
Toremove:
V-_Remove the drawers.
[-_-]Reach in, push the fiont of glass
cover up, and at the same time,
pull it forward as far as it will come.
Tilt it and rake it out. Avoid cleaning the
cold glass cover with hot water because
the extreme temperature difference may
cause it to break.
V_]Remove the drawer flame. (Always
remove the glass cover before you
rake out the drawer flame.)
I,ifl the flame off the supports at each
side and back, pull it forward, tilt it and
take it out.
Toreplace:
V-_ Lower the frame until it rests on the
supports at each side and back.
[-2--] Replace the glass cover, pushing its
rear edge firmly into the rear flame
channel and gently lowering the flont
into place.
[-_]Replace the drawers.
8