Reversing The Door Handles - GE CTS18HBSDRWW Owner's Manual And Installation Instructions

Installation Instructions
B REVERSING THE DOOR SWING
(CONT.)
141REVERSING THE HARDWARE
4.1 Remove the base grille (if your refrigerator has
one) by pulling it straight out.
4.2 Using a Torxdrive_, move the bottom hinge
bracket (and shim glued to it) and plastic washer
flom the right side to the left side.
11 I Plastic Washer
I
[] REVERSING THE DOOR HANDLES
Plug ,_
5.1 Transfer fresh food door handle
5.1.1
Remove the handle plug using a
tape-tipped putty knife under the edge,
and remove the screw underneath.
Remove the two screws holding the
handle to the top of the dooL
!
5.1.2 Remove the handle.
I
4.3 Interchange hinge (and the shim glued to it) and
screws at top right with screws at top left of cabinet.
Do not tighten screws on hinge side at this time.
Installingthe hingeon the left. Installingthe hinge onthe right.
NOTES:
• Some hinges have four holes. Which holes you
use for installing the hinge depends on which
side you install the hinge.
• The outer edge of the hinge should be parallel
to the edge of the case for correct installation.
5.1.3
Remove the screws flom the right edge of the
door top and insert them into the handle screw
holes on the opposite side.
5.1.4 With tape-tipped putty knife or thin-blade
screwdrivei; pry out the plug button flom the
hinge hole on the left side of the door and
insert it into the hole on the opposite side that
was vacated by removal of the top hinge.
PlugBu_
2O