Table of Contents
Advertisement
Available languages
Available languages
Installation
Instructions
I_] PLUG IN THE REFRIGERATOR
Arrange
the coil of tubing
so that it does not vibrate
against
the back of the refligerator
or against
the
wall. Push
the refligerator
back to the wall.
[]
START THE ICEMAKER
On power switch models, set the icemaker
power
switch to the / (0n) position.
On feeler arm models,
move the feeler arm to the ON (down) position.
The
icemaker will not begin to operate
until it reaches
its operating
temperature
of 15°F (-9°C) or below.
It will then begin operation
automatically.
I
Powerswitch model
,7
//
,'Y
//
.##;"_r--... F eeler Arminthe
.....
STOP (up) p osition
in
theON(down) position
Feeler a rmmodel
NOTE:
In lower water
pressure
conditions,
the
water
valve may tuin
on up to 3 times
to deliver
enough
water
to the icemaker.
REVERSING THE DOOR SWING
IMPORTANT
NOTES
When reversing the door swing:
• Read the instructions
all the way through before
starting.
• Handle parts careflflly to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching
work surface for
the doors.
IMPORTANT:
Once you begin, do not move the
cabinet until door-swing reversal is completed.
These insmlcfions
are for changing
the hinges flom
the right side to the left side--if you ever want to change
the hinges back to the right side, follow these same
insu-ucdons
and reverse all references
to left and right.
TOOLS REQUIRED
Phillips screwdriver
5/16" hex-head
socketdriver
Puttyknife or thin-blade
screwdriver
Masking tape
T20or T25Torxdriver,
whicheveryour model
requires
5/16" open-end
wrench
17
Advertisement
Table of Contents
