Table of Contents
Advertisement
CLEANING
• Clean engine, battery, seat, finish, etc.
of all foreign matter.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• Protect painted surfaces Withautomo-
tive type wax.
We do not recommend
using a garden
hose to clean your tractor unless the elec-
trical system, muffler, air filter and carbure-
tor are covered to keep water out. Water
in engine can result in a shortened engine
life.
_CAUTION:
Before performing
any service
or adjustments:
• Depress clutch/brake pedal fully and set parking brake.
• Place gearshift lever in neutral (N) posi,tion.
• Place attachment clutch in "DISENGAGED"
position.
• Turn ignition key "OFI_
and remove key.
• Make sure the blades and all moving parts have completely stopped.
• Disconnect
spark plug wire from_spark
plug and place wire where it cannot come
in contact with plug.
TRACTOR
TO REMOVE
MOWER
• Place attachment
clutch in "DISEN-
GAGED"
position.
• Turn height adjustment knob to lowest
setting.
Lower mower to its Iowes! position.
•
Remove retainer spring holding anti-
swaybar to chassis bracket and disen-
gage anti-swaybar
from bracket.
• Remove retainer springs from suspen-
sion arms at deck and disengage
arms
from deck.
• Raise attachment
lift to iis: highest posi-
tion.
• Remove
two retainer
springs from each
front
link and remove links.
• Slide mower forward
and remove belt
from electric clutch pulley.
• Slide mower out from under right side of
tractor.
IMPORTANT:
If an attachment other than
the mower deck is to be mounted on the
tractor, remove the front links.
TO INSTALL
MOWER
Follow procedure described in "INSTALL
MOWER
AND DRIVE
BELT" in the
Assembly section of this manual.
Adjustment
Nuts
Suspension
Arms
Chassis
Lift
Links
Front Mower
Bracket
Front
Bracket
Front
Suspension
Bracket
Retainer
Spring
Anti-Sway
Bar
Retainer
Springs
22
Retainer
Springs
Front Mower
Bracket
Advertisement
Table of Contents
