Maintenance; Blade Raising And Tilting Mechanism; Lubrication - Craftsman 137.248840 Operator's Manual

GENERAL MAINTENANCE
IA WARNING n
For your own safety, turn the switch OFF and
remove the switch kay. Remove the plug from
the power source outlet before maintaining or
lubricating your saw.
1. Clean out al! sawdust that has accumulated inside
the saw cabinet and the motor.
2. Polish the saw table with an automotive wax to keep
it clean and to make it easier to slide the work piece.
3. Clean cutting blades with pitch and gum remover.
4. A worn, cut, or damaged power cord should be
replaced immediately.
IA WARN Ne n
All electrical or mechanical repairs should be
attempted only by a trained repair technician.
Contact the nearest Seers Service Center for
service. Use only identical replacement parts. Any
other parts may create a hazard.
5. Use liquid dish washing detergent and water to clean
al! plastic part&
NOTE: Certain cleaning chemicals can damage
plastic parts.
6. Avoid use of the following cleaning chemicals or
solvents, ammonia and household detergents
containing ammonia_
BLADE RAISmNG AND TmLTmNGMECHANmSM
(FIGo LL)
After each five hours of operation, the blade raising
mechanism and tilting mechanism should be checked
for looseness, binding, or other abnormalities. With the
saw dis-connected from the power source, turn the saw
upside down and alternately pull upward and downward
on the motor unit. Observe any movement of the motor
mounting mechanism. Looseness or play in the blade
raising screw (1) should be adjusted as follows:
1. Using a wrench, loosen nut (2).
2. Adjust nut (3) until it is finger=tight against the
bracket (4), and then back off the nut (3) 1/6 turn.
3. Tighten nut (2) with the wrench, while holding nut (3)
in place. Maximum allowable play of screw rod (1) is
0.16 in. (4 mm).
Fig. LL
2
1
5
Place a small amount of dry lubricant on height
regulating bolt (1). This must be kept clean and free of
sawdust, gum, pitch, and other contaminants for smooth
operation.
If excessive looseness is observed in any parts of the
blade raising mechanism or tilting mechanism, take the
complete unit to a Sears Service Center.
LUBRICATmON
All motor bearings are permanently lubricated at the
factory and require no additional lubrication.
On all mechanical parts of your table saw where a pivot
or threaded rod are present, lubricate using graphite or
silicone. These dry lubricants wi!! not hold sawdust as
would oil or grease.
22