Unix; Overview; Configuration; Network Interface Card Setting - Olivetti d-Color P20W Network User's Manual

UNIX

O
VERVIEW
The printer supports many protocols such as LPD, FTP, TELNET,
SNMP and IPP, and works within the UNIX environment.
To use the network card within the UNIX environment, the
following steps are required:
C
ONFIGURATION
N I
ETWORK NTERFACE CARD SETTING
The first step in installing the network card under UNIX is to set
up the IP address, Subnet Mask and Gateway. This section
explains one way to set them up from a UNIX workstation.
> The network addresses used in this manual are shown as
examples only. Network addresses used in your
installation must be generated for your own network.
> Log in as [root] to change the configuration of the printer.
> If an incorrect IP address, Subnet Mask or Gateway is
entered, the network may go down or other damage may
occur. Check the address with your network manager.
The following explanation uses Sun Solaris 2.8 (Solaris 8) as an
example. The actual commands may differ between versions of
UNIX, so refer to the workstation manuals for more information.
NOTE:
If you do not have superuser rights, the network manger
should conduct the configuration.
1. Log in as [root] to the workstation
2. If the printer does not have an IP address already
assigned, use the arp command to set a temporary IP
address.
Example: for IP address 192.68.20.127 and network card
address 00:80:87:01:00:D2
# arp –s 192.168.20.127 00:80:87:01:00:D2 temp
UNIX> 69