Oki OKIPAGE 14EX Service Manual page 295

l
NO - When the paper is fed in, does the paper inlet jam occur?
l
YES - Is the paper being fed to above sensor plate (inlet)?
l
YES - Is the sensor plate (inlet) operating normally?
l
NO - Replace the sensor plate (inlet).
l
YES - Clean the inlet sensor on the power supply/sensor board or replace the power supply/sensor board or inlet sensor.
l
NO - Replace the roller-A or roller-B.
l
NO - Are the roller-A and roller-B rotating?
l
YES Set the paper properly.
l
NO - Is the pulse motor turning?
l
YES - Replace the planet gear.
l
NO - Is the connector cable being connected properly?
l
NO - Connect the connector cable properly.
l
YES - Check the coil resistance (approx. 32W) of the pulse motor. Is it normal?
l
NO - Replace the pulse motor.
l
YES - Replace the OLEV-11-PCB.
Copyright 2000, Oki Data, Division of OKI America, Inc. All rights reserved. See the Oki Data Business Partner Exchange
(BPX) for any updates to this material. (http://bpx.okidata.com)