Craftsman 536.773520 Operating Instructions Manual page 8

ASSEMBLY
ENGINE PREPARATION
Fill Crankcase With Oil
The trimmer was shipped with a container of
SAE30 motor oil. This oil must be added to the
engine before operating.
1, Remove the oil fill cap/dipstick shown in
Figure 4. Fill the crankcase to the FULL
line on oilfill cap/dipstick. DO NOT OVER-
FILL.
2. Install the oil fill cap/dipstick and tighten
securely.
Fill Fuel Tank With Gasoline
For the correct procedure and grade of
gasoline, see "How To Fill With Gasoline" in
the Operation section.
Fuel Cap
Oil Fill Cap/
Dipstick
Figure 4
ELECTRIC START BATTERY
When the mower was shipped from the facto-
ry, the battery was not fully charged. Before the
first use, the battery must be charged for
16-24 hours. See "How To Charge The Bat-
tery" in the Service And Adjustment section.
_" CHECKLIST
For the best performance and satisfaction
from this quality product, please review the fol-
lowing checklist before you operate the trim-
mer:
P" All assembly instructions have been
completed.
• _" Check carton. Make sure no louse parts
remain in the carton.
As you learn how to use the trimmer, pay extra
attention to the following important items:
r_P " Engine oil is at correct level.
J."_,_" Fuel tank is filled with fresh, clean, reg-
ular unleaded gasoline.
P",_" Become familiar and understand the
function of all controls. Before your start
the engine, operate all controls.
712344 8