Craftsman 536.773520 Operating Instructions Manual page 17

SERVICE AND ADJUSTMENT
HOW TO ADJUST I
THE HEIGHT OF THE HANDLE
I Handle
Use the knoba, on each side of the handle, to
adjust the height of the handle.
1. Hold the handle with one hand and loosen
both knobs until the ratchet teeth are dis-
engaged. Do not remove the knobs. See
Figure 17.
2. Move the handle up or down to the de-
sired position, then align the ratchet
teeth. Make sure both sides of the handle
are level.
Ratchet
Teeth
3. Tighten the knobs.
I
HOW TO SET THE HEIGHT OF CUT
CAUTION: Before you set the
height of cut: stop the engine.
Wait for all moving parts to stop.
Allow the engine to cool and dis-
connect the spark plug wire.
The height of cut can be set from 1-1/'2 inches
to 3 inches. Recommended cutting height for
the average yard is 2".
1, Use the T-wrench, found in the parts bag,
to loosen the set screw shown in
Figure 18,
2. Set the trimmer head at the desired
height.
3. Tighten the set screw.
Height Of
Set Screw
Height Guide
.__t;
Trimmer
Head
Rgure 18
712344 17