To Replace Headlight Bulb; To Adjust Attachment Lift Spring; Engine; To Adjust Throttle Control Cable - Craftsman 917.275010 Owner's Manual

TO REPLACE HEADUGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the gdll.
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractorto run poorly,stop running, or
prevent it from starting.
• Check wiring, See electdcal widng
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug_nfuse. The fuse holder is located
behind the dash.
TO ADJUST ATTACHMENT LIFT
SPRING
1. While holding spdng bushing with
wrench, loosen jam nut.
• Turn adjustment holt clockwise to
extend spdng and reduce lift effort for
heavier attachments.
• Turn adjustment holt eountemlockwise
for lighter attachments.
2. Retighten jam nut against spdng
bushing.
IMPORTANT: Do not edjust for maximum
spdng tension when using light attach-
ments such as a mower. Adjust lift lever
spring to aid in lifting attachment. Do not
overpower spdng. When removing
attachment, always adjust spring tension
to its lowest position.
Adjustment Bolt Spring
Headlight Wire
Connector
ENGINE
Maintenance, repair, or replacement of
the emission control devices and sys-
tems, which are being done at the
customers expense, may be performed
by any non-reed engine repair establish-
ment or individual.Warranty repairs must
be performed by an authorized engine
manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be
necessary. Check adjustment as de-
scdbed below before loosening cable. If
adjustment is necessary, proceed as
follows:
1. With engine not running, move throttle
control lever to fast position.
2. Check that speed control lever is
against stop screw. If it is not, loosen
casing clamp screw and pullthrottle
cable until lever is against screw.
Tighten clamp screw securely.
IdLespeed Adjusting
Throttle
Control
Attachment L ift
Jam Nut Spring
TO REMOVE HOOD AND GRILL
ASSEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. To replace, reverse above procedure. 27
Stop
ClamF
Choke Control Cable