Service And Adjustments; To Remove Mower; To Install Mower; To Level Mower Housing - Craftsman 917.275010 Owner's Manual

CAUTION: BEFORE PERFORMING ANY SERVICE ORADJUSTMENTS:
l. Depress clutch/brake pedal fully and set parking brake. 2. Place gearshift lever in neutral (N)position.
3. Place attachment clutch in "DISENGAGED" position.
4. Turn ignition key "OFF" and remove key,
5. Make sure the blades and all moving parts have completely stopped,
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TRACTOR
TO REMOVE MOWER
1. Place attachment clutch in "DISEN-
GAGED" position.
2. Turn height adjustment knob to lowest
setting.
3. Lower mower to its lowest position.
4. Remove retainer spring holding anti-
swaybar to chassis bracket and
disengage anti-swaybar from bracket,
5. Remove four retainer springs from
front plate assembly and remove
plate.
6. Remove retainer springs from
suspension arms at deck and disen-
gage arms from deck.
7. Raise attachment lift to its highest
position.
8. Slide mower forward and remove belt
from electric clutch pulley.
9. Slide mower out from under right side
of tractor.
TO INSTALL MOWER
Follow procedure described in "INSTALL
MOWER AND DRIVE BELT" in the
Assembly section of this manual.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked
on level ground or driveway. Make sure
tires are propedy inflated (See "PRODUCT
SPECIFICATIONS" section of this manual).
If tires are over or underinflated, you will
not properly adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position,
• Measure height from bottom edge of
mower to ground level at front comers of
mower, Distance =A" on both sides of
mower should be the same.
• If adjustment is necessary, make
adjustment on one side of mower only.
• To raise one side of mower, tighten lift
link adjustment nut on that side.
• To lower one side of mower, loosen lift
link adjustment nut on that side.
NOTE: Each futlrum of adjustment nut
will change mower height about 3/16".
• Recheck measurements after adjusting.
Bottomedgeof Bottom edge of
gmr°uW_n _ t_n%roW_rnt _
Chassis
Bracket
Suspension
Arms
Front Mower Electnc
Bracket Pulley
Front Plate
Retainer
Spnn
Anti-Sway
Bar
Retainer
• Retainer Springs
22