Table of Contents
Advertisement
ASSEMBLY
JNSTRUCTmONS
[AWARNmNG 1
For your own safety, never connect plug to power
source outlet until all assembly steps are complete and
you have read and understood the safety and operating
instructions.
[AWARN NG
I
The drill press is a heavy power too! and should be
lifted with the help of two PEOPLE OR MORE to safely
assemble it.
ASSEMBUNG
COLUMN TO BASE (FIG. A)
1. Position the base (2) on a flat worksurface.
2. Place the column (1) on the base, aligning the
mounting holes to the base.
3. Locate the three hex bolts (3) from the loose parts
bag.
4. Place a bolt in each hole through the column support
and thread into the base. Tighten with a 12ram
wrench.
Fig. A
NOTE: Table removed from bracket in illustration for
clarity.
Fig. B
1
3. Place the rack (5) inside the table bracket (3), making
sure the worm gear (1) on the inside of the table
bracket is engaged with the teeth of the rack and the
arrow stamped on the rack is pointing up.
Fig. C
INSTALLING
TABLE TO COLUMN ASSEI_IBLY
(FIG. B THROUGH F)
1. Insert the worm gear (1) into the table crank handle
hole (2) from inside the table support (3). Make sure
the worm gear (1) meshes with the inside raising/
lowing gear_
2. Instal! the table bracket lock handle (4) into the hole
at the rear of the table bracket assembly. NOTE:
Instal! the handle from left to right, so it enters the
non-threaded side of the table bracket first as shown
in Fig. C.
10
Hide quick links:
Advertisement
Table of Contents
