Craftsman 358.794704 Operator's Manual page 12

5. Fully s queeze the throttle trigger to
disengage the starting system ( start
lever returns toRUN p osition).
6. Pull starter rope handle with acon-
trolled a nd steady motion while
squeezing throttle trigger until
engine starts a nd runs.
STARTING A WARM ENGINE
1. Squeeze and hold the throttle trigger.
2. Pull starter rope handle with a con-
trolled and steady motion while
squeezing throttle trigger until en-
gine starts and runs.
NOTE: Normally, the warm starting pro-
cedure can be used within 5-10 minutes
after the unit is turned off. If the unit sits
for more than 10 minutes without being
used, it will be necessary to start the unit
by following the steps under STARTING A
COLD ENGINE or following the starting
instruction steps shown on the unit.
STARTING A FLOODED ENGINE
Flooded engines can be started by
moving the start lever to the RUN posi-
tion and fully squeezing the throttle
trigger. Pull the starter handle repeat-
edly while squeezing throttle trigger
until engine starts and runs. This could
require pulling the starter handle many
times, depending on how badly the
unit is flooded. If the unit still doesn't
start, refer to the TROUBLESHOOTING
TABLE or call 1-800-235-5878.
CUSTOMER RESPONSIBILITIES
,_ WARNING: Disconnect the spark plug before performing maintenance,
service, or adjustments.
CARE & MAINTENANCE TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Inspect and clean unit and labels
Clean air filter
Replace spark plug
Replace fuel filter
Check muffler mounting screws
,_ WARNING: Avoid touching muf-
fler unless engine and muffler are cold.
A hot muffler can cause serious burns.
_ILWARNING: Stop engine and be
sure the impeller blades have stopped
turning before opening the vacuum in-
let door or attempting to insert or re-
move the vacuum or blower tubes.
The rotating blades can cause serious
injury. Always disconnect the spark
plug before performing maintenance or
accessing movable parts.
GENERAL RECOMMENDATIONS
The warranty on this unit does not cov-
er items that have been subjected to
operator abuse or negligence. To re-
ceive full value from the warranty, the
operator must maintain unit as instruct-
ed in this manual. Various adjustments
will need to be made periodically to
properly maintain your unit.
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
Yearly
Yearly
Yearly
CHECK FOR LOOSE
FASTENERS AND PARTS
• Muffler
• Spark Plug Boot
• Air Filter
• Housing Screws
CHECK FOR DAMAGED OR
WORN PARTS
Contact Sears Service Center for re-
placement of damaged or worn parts.
• Fuel Tank - Do not use unit if fuel tank
shows signs of damage or leaks.
• Vacuum Bag - Do not use vacuum
bag if it is torn or damaged.
INSPECT AND CLEAN UNIT
AND LABELS
• After each use, inspect complete unit
for loose or damaged parts. Clean
the unit using a damp cloth with a
mild detergent.
• Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine per-
formance and increases fuel consump-
tion and harmful emissions. Always
clean after every 5 hours of operation.
-12-