Tools Required For Assembly - Craftsman 917.276211 Owner's Manual

"{our new tractor has been assembled at the factory with the exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier, Standard wrench sizes you need
are listed below_
(1) 9/16" wrench (1) Pliers
(1) 1/2"wrench (t) Utility knife
(1) 3/4" socket with drive ratchet
(1) Tire pressure gauge
When right or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating posi-
tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1_ Remove all accessible loose parts and
parts boxes from carton,
2, Cut along dotted lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
3, Remove mower and packing materials.
4. Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
ATTACH STEERING WHEEL
1_ Remove locknut and large flat washer
from steering shaft.
2. Position front wheels of the tractor so
they are pointing straight forward,
3. Slide the steering sleeve over the
steering shaft.
4o Position steering wheel so cross bars
are horizontal (left to right) and slide
onto steering wheel adapter.
5. Secure steering wheel to steering
shaft with Iocknut and large flat washer
previously removed. Tighten securely,
6, Snap steering wheel insert into center
of steering wheel.
7. Remove protective materials from trac-
tor hood and grill,
IMPORTANT: Check for and remove any
staples in skid that may puncture tires
where tractor is to roll off skid.
..Steering Wheel
_'_-_> Lock Nut
_--___._ Large Flat
Steering Wheel@ Washer
Steering
Steering _------_Whe el
•_--_._ Adaptor
Shaft *_--'- - :-._
Steenng _;_2 -,_ ,, ,::
Sle .f,.,, ,,
'. . " ="= ' J ',,
CHECK BAI-FERY
1o Lift hood to raised position,
NOTE: If this battery is put into service
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps. (See "BATTERY" in Maintenance
section of this manual for charging instruc-
tions),
/
[.abel