Check Tire Pressure - Craftsman 917.276211 Owner's Manual

Belt Tension Rod
Position
Gauge
Wheel
Bracket
ElectricClutch Pulley
Front Plate Assembly
DoubTe Loop
Retainer Springs
.,p
Front Mower Bracket
Flanged Pin -
Position Notch
Vertically
Rear Mower Pins
CHECKTIRE PRESSURE
The tires on your tractor were overinflated
at the factory for shipping purposes. Cor-
rect tire pressure is important for best
cutting performance.
o Reduce tire pressure to PS! shown in
"PRODUCT SPECIFICATIONS" section
of this manual.
CHECK DECK LEVELNESS
For best cutting results, mower hous-
ing should be properly leveled. See "TO
LEVEL MOWER HOUSING" in the Service
and Adjustments section of this manual.
CHECK FOR PROPER POSITION
OF ALL BELTS
See the figures that are shown for replac_
ing motion and mower blade drive belts
in the Service and Adjustments section
of this manual. Verify that the belts are
routed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your trac--
tor, check to see that the brake is properly
adjusted. See "TO ADJUST BRAKE" in
the Service and Adjustments section of
this manual.
,/CHECKLIST
Before you operate your new tractor, we
wish to assure that you receive the best
performance and satisfaction from this
Quality Product.
Please review the following checklist:
Deflector Shield
,/All assembly instructions have been
completed.
¢" No remaining loose parts in carton.
v" Battery is properly prepared and
charged. (Minimum 1 hour at 6 amps).
v" Seat is adjusted comfortably and tight-
ened securely.
¢ All tires are properly inflated. (For ship-
ping purposes, the tires were overin-
flated at the factory).
¢ Be sure mower deck is properly leveled
side-to-stde/front-to-rear for best cutting
results. (Tires must be properly inflated
for leveling).
v" Check mower and drive belts. Be sure
they are routed properly around pulleys
and inside all belt keepers.
,/Check wiring. See that a!l connections
are still secure and wires are properly
clamped.
While learning how to use your tractor, pay
extra attention to the following important
items:
v' Engine oil is at proper level.
v" Fuel tank is filled with fresh, clean, regu-
lar unleaded gasoline,
,/Become familiar with all controls, their
location and function_ Operate them
before you start the engine.
¢ Be sure brake system is in safe operat-
ing condition.
¢ Be sure Operator Presence System and
Reverse Operation System (ROS) are
working properly (See the Operation and
Maintenance sections in this manual).
11