Engine Oil Filter; Clean Air Screen - Craftsman 917.276211 Owner's Manual

I. Remove oil fill cap/dipstick. Be careful
not to allow dirt to enter the engine
when changing oil.
2. Install the drain tube onto the valve.
& Open drain valve by using a 7/16"
(1 lmm) wrench turning counterclock-
wise,
4, After oil has drained completely, close
the drain valve turning clockwise° Use
the 7/16" (11 mm) wrench to apply
a small amount of torque to keep it
closed° Do not over tighten.
5. Remove the drain tube and store in a
safe place,
6 Refill engine with oil through oil fill dip-
stick tube. Pour slowly Do not overfill.
For approximate capacity see "PROD-
UCT SPECIFICATIONS" section of
this manual°
7. Use gauge on oil fill cap/dipstick for
checking level, For accurate reading,
tighten dipstick cap securely onto the
tube before removing dipstick. Keep
oil at "FULU' line on dipstick. Tighten
cap onto the tube securely when fin-
ishedo
Oil Drain Valve
To Open
To C!ose
Drain Tube
ENGINE OIL FILTER
Replace the engine oil filter every season
or every other oil change if the tractor is
used more than 100 hours in one year.
AIR FILTER
Your engine will not run properly using a
dirty air filter. Clean the foam pre-cleaner
after every 25 hours of operation or every
season. Service paper cartridge every
100 hours of operation or every season,
whichever occurs first.
Service air cleaner more often under
dusty conditions.
1, Remove cover.
TO SERVICE PRE-CLEANER
2. Wash it in liquid detergent and water.
3. Squeeze it dry in a clean cloth.
4, Saturate it in engine oil, Wrap it in
clean, absorbent cloth and squeeze to
remove excess oil.
NOTE: If very dirty or damaged, replace
pre-cteaner.
TO SERVICE CARTRIDGE
1. Clean cartridge by tapping gently on
flat surface, If very dirty or damaged,
replace cartridge.
2. Reinstall precleaner cartridge, cover
and secure.
IMPORTANT; Petroleum solvents, such as
kerosene, are not to be used to clean the
cartridge. They may cause deterioration
of the cartridge, Do not oil cartridge. Do
not use pressurized air to clean or dry
cartridge.
Fos.m
CLEAN AIR SCREEN
Air screen must be kept free of dirt and
chaff to prevent engine damage from
overheating, Clean with a wire brush or
compressed air to remove dirt and stub-
born dried gum fibers.
CLEAN AIR INTAKE/COOLING AREAS
To insure proper cooling, make sure the
grass screen, cooling fins, and other exter-
nal surfaces of the engine are kept clean at
all times.
Every 100 hours of operation (more often
under extremely dusty, dirty conditions),
remove the blower housing and other
cooling shroud& Clean the cooling fins and
external surfaces as necessary. Make sure
the cooling shrouds are reinstalled.
NOTE: Operating the engine with a
blocked grass screen, dirty or plugged
cooling fins, and!or cooling shrouds re-
moved will cause engine damage due to
overheating.
21