Tools Required For Assembly; Install Steering Wheel - Craftsman EZ 917.270941 Owner's Manual

20.0 hp electric start 42" mower automatic
Table of Contents

Advertisement

Your new tractor has been assembled at the factory with exception
of those parts left
unassembled
for shipping
purposes.
To ensure safe and proper operation
of your
tractor all parts and hardware you assemble
must be tightened
securely.
Use the
correct tools as necessary
to insure proper tightness.
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier.
Standard wrench sizes you need
are listed below.
(1) 9/16" wrench
(1) Pliers
(2) 1/2" wrench
(1) Utility knife
(1) Tire pressure
gauge
When right or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating
position (seated behind the steering
wheel).
TO REMOVE
TRACTOR
FROM
CARTON
UNPACK
CARTON
• Remove all accessible
loose parts and
parts boxes from shipping carton.
• Cut, from top to bottom, along lines on
all four corners of shipping
carton, and
lay panels flat.
• Check for any additional loose parts or
boxes and remove.
BEFORE REMOVING TRACTOR
FROM SKID
ATTACH STEERING WHEEL
ASSEMBLE
EXTENSION
SHAFT AND
BOOT
• Slide extension
shaft onto lower
steering shaft.
Align mounting
holes in
extension
and lower shafts and install
5/16 hex bolt and Iocknut.
Tighten
securely.
° Place tabs of steering boot over tab
slots in dash and push down to secure.
• Assemble
large flat washer, 3/8 lock
washer, 3/8 hex bolt and tighten
securely.
• Snap steering wheel insert into center
of steering wheel.
• Remove
protective
materials
from
tractor hood and grill.
IMPORTANT:
Check for and remove any
staples in skid that may puncture
tires
where tractor is to roll off skid.
Extension
Shaft _
Adapter
5/16 Locknut__.
_
5/o116 H ex
Lower
'
"-
'
Steering _
_
Tabs
Shaft
_, " . . .
_
,
Slots
INSTALL STEERING
WHEEL
• Position front wheels of the tractor so
they are pointing straight forward.
• Remove steering
wheel adapter from
steering wheel and slide adapter
onto
steering shaft extension.
• Position steering wheel so cross bars
are horizontal
(left to right) and slide
inside boot and onto adapter.
7

Advertisement

Table of Contents
loading

Table of Contents