Craftsman 113.243401 Owner's Manual page 10

assembly
MOUNTING PULLEY
1. Loosen setscrew in the motor pulley and place the
pulley on the shaft with the hub flush with the end of
the shaft. Insert the motor shaft key and tighten the
setscrew with 5/32" setscrewwrench.
When installing the pulley on a 1/2" diameter motor
shaft, make sure that the adapter sleeve and 3/16"
square key furnished with your motor are in place.
Then tighten the setscrewwith a 5/32" setscrew wrench.
SETSCREW | - '
WRENCH _ 3/16x 3/16 KEY
\ ",
ADAPTER
SLEEVE
MOTOR 1/2 I_IA. MOTOR
FLUSH HERE SHAFT SHAFT
KEY
CHECK MOTOR ROTATION
NOTE: Motor supplied with Model No. 113.243411 only.
The motor must rotate COUNTERCLOCKWISE when
viewed from the PULLEY end.
1. Place the motor on your workbench or on the floor.
2. Stand clear of the motor and plug the cord into a pro-
perly grounded outlet (See page 4). Notice the rotation
of the pulley. If it is not turning COUNTERCLOCK-
WISE, REMOVE the plug from the outlet, and change
the rotation of the motor according to the instructions
furnished with the motor.
WARNING: FOR YOUR OWN SAFETY, MAKE SURE
PLUG IS NOT CONNECTED TO POWER SOURCE OUT-
LET WHEN CHANGING MOTOR ROTATION.
MOUNTING MOTOR
I. Find four 5/16"-18 x 1" carriage bolts, flat washers,
lockwashers and nu_ supplied with the base.
2. Insert the bolts through the holes marked "X" from
behind the motor mount bracket.
3. Attach the motor . . . place a flat washer and a
Iockwasher on each bolt . . . screw on the nuts but
DON'T TIGHTEN them.
4. Loosen the two BELT GUARD SUPPORT SCREWS.
5. Loosen the two MOTOR BASE CLAMP SCREWS and
rotate the motor so that the ventilation holes are
facing downward.., tighten the screws.
O
L3
MOTOR MOUNT
BRACKET
[]
[]
& Tighten the BELT GUARD SUPPORT SCREWS.
I0