Advertisement
,_,
WARNING:
Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
SWITCH
See Figure 2.
To turn your drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
,4_
WARNING:
Do not allow familiarity with your drill-
driver to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
severe injury.
CHARGING
BATTERY
PACK
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it at least 3 to 5 hours prior to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (drilling followed
by recharging) for them to become fully charged.
TO CHARGE
•
Charge battery pack only with the charger and
charging stand provided.
•
Make sure power supply Is normal house voltage,
120 volts, 60 Hz, AC only.
•
Connect charger to power supply.
•
Place battery pack in charging stand. Align raised rib
on battery pack with groove in charging stand.
See Figure 1.
•
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charging
stand.
•
When properly connected, the red light on charging
stand will turn on.
•
Note: If charger does not charge battery pack, retum
battery pack, charger and charging stand to your nearest
Sears Repair Center for electrical check.
•
After normal usage, 3 hours of charging time is
required to be fully charged. A minimum charge time
of 3 to 5 hours is required to recharge a completely
discharged tool.
•
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
•
Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
•
When batteries become fully charged, unplug charger
from power supply.
SELECTOR
CENTERPOSITION
(LOCK)
SWITCH
TRIGGER
Fig. 2
VARIABLE
SPEED
This tool has a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed
is controlled by the amount of switch trigger depression.
Note: You might hear a whistling or ringing noise from the
switch during use. Do not be concerned, this is a normal
part of the switch function.
SWITCH
LOCK
See Figure 2.
The switch trigger can be locked in the OFF position. This
feature can be used to prevent the possibility of accidental
starting when not in use. To lock switch trigger, place the
direction of rotation selector in center position.
_kWARNING:
Battery tools are always in operating
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
7
Advertisement
