Clean Filters; Motor Filter; Replacement Filters; Cleaner Care - Sanitaire 200 Series Owner's Manual

Household type

Hide thumbs Also See for 200 Series:

Table of Contents

Clean Filters

Check and clean filters as needed. Remove filters to shake them vigorously and brush

off dust and lint. Both filters are washable, see instructions below.

NOTE: Unplug electrical cord and turn off power switch before servicing. Never

operate vacuum cleaner without filters.

Clean motor filter after each use. Replace

filter if damaged.

To remove motor filter from frame, pull

back on rubber gasket at top of the filter

and remove from frame.

To replace motor filter onto frame, pull

new filter over frame and secure lip on

frame into gasket.

Final Filter

Clean final filter as needed.

Washable Filters

If filters need further cleaning, launder

them in warm water using a mild detergent.

Air dry thoroughly before replacing filters

into cleaner.

If filters are damaged or extremely soiled, replace them.

Use replacement motor filter, part 54865 and final filter, number 38596.

Both are available from a local dealer or The Eureka Company.

NOTE: Turn off power switch and unplug electrical cord before cleaning unit.

To keep vacuum cleaner looking new, it can be wiped with a damp cloth and mild soap

solution, then thoroughly dried. Never use any type of chemical as they can damage

the cleaner. When not in use, store cleaner in a clean, dry place.

Final Filter

Pull motor filter

from frame

Table of Contents