Advertisement
Available languages
Available languages
RULES FOR SAFE OPERATION (Continued)
41_
An extension cord should not be used unless
43.
absolutely
necessary° Use of improper extension
cord could result in a risk of fire and electric shock.
If extension
cord must be used, make sure:
44.
a.
That _ins on plug of extension
cord are the
same number, size and shape as those of plug
on charger°
b.
That extension
cord is properly wired and in
45.
good electrical
condition;
and
c.
That wire size is large enough for' AC ampere
rating of charger as specified
below:
! .... AwGSize
of Cord/Length
0f Cord'
Feet
I
Feet
25
50
100
150
AWG
16
16
16
16
46.
47.
48.
42_
DO
NOT
OPERATE
CHARGER
WITH
A
DAMAGED
CORD OR PLUG. If damaged,
have
replaced immediately
by a qualified serviceman°
Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way; take it to a qualified
serviceman.
Do not disassemble
charger; take it to a qualified
service_nan when service
or repair' is required_
Incorrect reassembly may result in a risk of electric
shock or fire.
To reduce risk of electric shock, unplug charger
from outlet before attempting any maintenance
or
cleaning. Turning off controls will not reduce this
risk.
Do not use charger outdoors.
Disconnect
charger from power supply when not
in use.
SAVE THESE
INSTRUCTIONS.
Refer to them
frequently and use them to instruct others who may
use this toot. if you loan someone
this tool, loan
them these instructions
also.
WARNING:
If any parts are missing, do not operate your drill until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
L J _LI
iiii
iiiiiiiiiii
WARNING:
Do not allow familiarity with your drill to make you
careless° Remember that a careless fraction of a second
is sufficient to inflict severe injury,,
IMPORTANT INFORMATION
FOR
RECHARGING
BATTERIES
When using your drill continuously, the batteries in your
battery pack will become hoL You should let a hot battery
pack cool down for approximately 30 minutes before at-
tempting to recharge_
NOTE: This situation only occurs when continuous use of
your drill causes the batteries to become hoL It does not
occur under normal circumstances. Refer to "CHARGING
YOUR DRILL" for normal recharging of batteries. If the
charger does not charge your battery pack under normal
circumstances, return both the battery pack and charger to
your nearest Sears repair center for electrical check.
Page 4
Advertisement
