Download Print this page

Craftsman 315.111720 Owner's Manual page 3

3/8 inch cordless drill two-speed / reversible
Hide thumbs Also See for 315.111720:

Advertisement

Available languages

Available languages

RULES FOR SAFE OPERATION (Continued)
21_ DO NOT USE TOOL IF SWITCH
DOES
NOT
TURN IT ON AND OFF. Have defective switches
replaced by an authorized service center.
22_ DRUGS,
ALCOHOL,
MEDICATION.
Do not
operate toot while under the influence of drugs,
alcohol, or any medication.
31,
23° DRILLING
OR
DRIVING
SCREWS
INTO
ELECTRICAL
WIRING
IN WALLS,
CEILINGS,
OR OTHER AREAS CAN CAUSE THE BIT OR
32.
CHUCK TO BECOME ELECTRICALLY
LIVE. Do
not touch metal parts when drilling into a wall;
33°
grasp onlythe insulated handle(s) or plastic housing
when using this tool. Make sure hidden electrical
wiring, water pipes, and mechanical
hazards are
not in the path of the bit when drilling into a wail
24_ INSPECT
FOR and remove all nails from lumber
34.
before drilling.
RULES
FOR
IMPORTANT
SAFETY
BATTERY TOOLS
and water,
then neutralize
with lemon
juice or
vinegar. If liquid gets in your eyes, flush them with
clean water for at least 10 minutes,
then seek
immediate
m,edical attention,
tf carrying your battery tool at your side, make sure
it is not running and your finger is not on the switch,
Avoid accidental
starting°
SECURE
WORK before applying
power. NEVER
hold workpiece
in your hand or across your legs.
WHEN
SERVICING
USE
ONLY
IDENTICAL
CRAFTSMAN
REPLACEMENT
PARTS.
IMPORTANT
SAFETY
FOR CHARGER
35.
25.
Battery
tools do not have to be plugged into an
electrical
outlet;
therefore,
they are always
in
operating condition.
Be aware of possible hazards
when not using your battery tool or when changing
36.
accessories.
26° USE ONLY THE CHARGER
PROVIDED
WITH
YOUR BATTERY
TOOL.
Do not substitute
any
other charger. Use of another charger could cause
batteries to explode causing possible serious injury.
27° DO NOT PLACE
BATTERY
TOOLS OR THEIR
37°
BATTERIES
NEAR
FIRE OR HEAT, They may
38°
explode°
28,
DO NOT CHARGE
BA'I-rERY
TOOL IN A DAMP
OR WET LOCATION.
iNSTRUCTIONS
29° Your battery tool should be charged in a location
where the temperature
is more than 50°F but tess
than 100°F.
30° Under extreme
usage or temperature
conditions,
battery
leakage
may occur. If liquid comes
in
contact with your skin, wash immediately with soap
39°
40_
SAVE
THESE
INSTRUCTIONS.
This manual
contains
important
safety
and
operating
instructions
for battery charger
part number
999555-007.
Before using battery charger, read all instructions
and cautionary markings in this manual, on battery
charger, and product using battery, charger.
WAIRNBNG:
To reduce
risk of injury, charge
only nickel-
cadmium
type rechargeable
batteries.
Other
type_, of batteries
may burst causing personal
injury and damage,
Do not expose charger to rain or snow°
Use of an attachment
not recommended
or sold
by the battery charger manufacturer
may result in
a risk of fire, electric shock, or injury to persons°
To reduce risk of damage
to charger
body and
cord, pull by charger body rather than cord when
disconnecting
charger_
Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise
subjected
to damage or stress,.
WARNnNG'.
The operation of any power tool can result in foreign objects being thrown into your eyes,
which can result in severe eye damage. Before beginning power tool operation, always wear
safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with
side shields, available at Sears Retail Stores.
Page 3

Advertisement

loading