Craftsman 113.29570 Owner's Manual page 15

. GETTING TO KNOW YOUR SAW
MITER GAUGE 7 BLADE GUARD ANTtKICKBACK
LOCK KNOB PAWLS
MITER GAUGE 9 SAW BLADE SPREADER 5
6 MITER GAUGE HEAD R_P FENCE
\
HOLES FOR
FACING
4 Tilt HANDWHEEL
3 ELEVATION
RIP FENCE
LOCK KNOB
2 RESET BUTTOt
!
0 N-OFF SWITCH
I ON-OFF SW,TCR II;
CAUTION: Before turning switch on, make sure the blade
guard is correctly installed and operating properly.
The On-Off Switch has a locking feature. THIS SHOULD
PREVENT UNAUTHORIZED AND POSSIBLY
HAZARDOUS USE BY CHILDREN AND OTHERS.
A. Insert key into switch.
B. TO turn saw ON .,, stand to either side of the
blade never in line with it , ,. insert finger under
switch lever and pull END of lever out.
After turning switch ON, always allow the blade to
come up to full speed before cutting.
Do not cycle the motor switch on and off rapidly,
as this may cause the sawblade to loosen, In the
event this should ever occur, allow the sawblade to
come to a complete stop and retighten the arbor
nut normally, not excessively. Never leave the saw
while the power is "ON".
C. TO turn saw OFF .,. PUSH lever in, Never leave
the saw until the cutting tool has come to a
complete stop.
D. TO lock switch in OFF position,., hold switch IN
with one hand .., REMOVE key with other hand.
WARNING: FOR YOUR OWN SAFETY, LOWER
BLADE OR OTHER CUTTING TOOL BELOW
TABLE SURFACE. (IF BLADE IS TILTED.
RETURN IT TO VERTICAL (90 ° ) POSITION).
ALWAYS LOCK THE SWITCH "OFF". WHEN
SAW I:S NOT IN USE ,.. REMOVE KEY AND
KEEP IT IN A SAFE PLACE ... ALSO ... IN
THE EVENT OF A POWER FAILURE (ALL OF
YOUR LIGHTS GO OUT) TURN SWITCH OFF
... LOCK IT AND REMOVE THE KEY. THIS
WILL PREVENT THE SAW FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK ON.
KEY
ON-OFF SWITCH
--4z:_j j
@
KEY
YELLOW PLASTIC)
F
/
15