Manual Tuning; Auto-Scan Tuning - Eton Sound 100 Owner's Manual

USING THE HEADPHONES/EARPHONES
Before place Earphone/Headphone in/on you ears, turn the volume
all the way down. Use Headphone/Earphone with 1/8 inch (3.5 mm)
stereo plug. Plug them into the earphone socket on the back of the
Etón Sound Radio.
SELECTING AM/FM OR LINE-IN
After turning on the radio, use sequential presses of the MODE but-
ton on the radio or the remote to select AM/FM or LINE-IN.

MANUAL TUNING

Use quick, short presses of the TUNING/SET buttons to tune up + or
down — frequency, or use the remote's TUNE +/- buttons.

AUTO-SCAN TUNING

With auto-scanning the radio stops at the next station with good
signal strength. Auto-scan tuning is engaged by a long, 2 second
press of the TUNING/SET buttons. To auto-scan up frequency, press
- button. To auto-scan down frequency, press the + button, or use
the remote's TUNE +/- buttons.
WORKING WIT MEMORY PRESETS
There are 10 memory presets total, 5 each for AM, FM. Note that the
procedures below will also overwrite what has been previously stored
into the memory. That is, a memory cannot be 'erased', but can be
overwritten.
1. Using the procedures described previously, tune to the radio
station that you wish to store.
ETÓN SOUND 100 OWNER'S MANUAL
3