Accessing What Is Stored Into Memory; Direct Memory Access; Memory Search; Memory Autoscan - Grundig Eton YB550 Operation Manual

ACCESSING WHAT IS STORED INTO MEMORY

Below, the three ways to access what has been stored into
memory are described: Direct Memory Access, Memory Search
and Memory Autoscan. When the memory page and memory
preset numbers appear in the upper right corner of the dis-
play, as it will in the sections below, the radio is in MEMORY
ACCESS MODE. This mode can be exited any time with a
press/release of the M.Scan/Page button.
DIRECT MEMORY ACCESS: To directly access a memory pre-
set, the page number and preset number must be entered, as
shown below:
1. Press/hold the M.Scan/Page button for about 3
seconds.Then release it. Note that the memory page is
flashing in the upper right corner of the display.
2. Within 5 seconds select the desired page with the + and
– buttons.
3. Within 5 seconds, use the numeric keypad to key-in the
memory preset number that you wish to access. (if it is
under 10, key in 01, 02, etc.). NOTE: Once a page number
has been selected or changed, even if it is not seen on the
screen, a memory preset on that page can be selected by
keying in the memory number with the numeric keypad,
without having to re-do steps 1 and 2 above.
34
Y B 5 5 0 P E
MEMORY
MEMORY SEARCH: Memory Search enables searching
through the memory presets within a memory page, as
shown below:
1. Press/release the M.Scan/Page button.
2. Use quick, short presses on the + or – buttons to search
through the memory presets.
MEMORY AUTOSCAN: Memory Autoscan enables scanning
through the memory presets within a memory page. The
memory being scanned enables listening to the station for
about 5 seconds and will then move on to the next memory
automatically. Autoscan will continue indefinitely on the
selected page until deliberately stopped.
1. Press/release the M.Scan/Page button.
2. Press/hold either the + or – button for about 3 seconds.
Then release it. Note that the memory preset number in
the upper right corner of the display flashes and the pre-
set being scanned remains for about 5 seconds. It then
moves on to the next memory preset for another 5 sec-
onds. To stop memory preset autoscan, press/release
either the + or – button.
O P E R A T I O N M A N U A L
35