Advertisement
CHARGER
._
See Figure 2.
Your charger has a "key hole" hanging feature for
convenient, space saving storage. Screws should be
installed so that center distances are 1-7/16 inches
apart.
YELLOW ANDGREENLIGHTS
INDICATESOFT STARTMODE
GREENUGHT "ON"
INDICATESFULLYCHARGED
RED LIGHT"ON"INDICATES
FASTCHARGING MODE
BATTERY
CHARGER
BATI'ERYPACK
14/16 in.
BACKSIDEOFCHARGER
Fig. 2
IMPORTANT
INFORMATION
FOR RECHARGING
HOT BA'I-rERIES
When using your ddU-driver continuously, the batter-
ies in your battery pack will become hot. You should
let a hot battery pack cool down for approximately 30
minutes before attempting to recharge. When the
battery pack becomes discharged and is hot, this will
cause the yellow and green lights on your battery
charger to come on instead of the red light. The
yellow and green lights indicate soft start mode and
will switch to green only, indicating slow charge mode.
The red light indicates fast charge mode, 1 hour
charge time. The green light indicates slow charge
mode, requiring overnight charging for batteries to
reach full charge. If the green light comes on after
letting battery pack cool down, remove it from charger
for additional cooling. Once the battery pack cools
down, you can recharge battery pack in fast charge
mode as normal. Do not leave a hot battery pack in
charger until it cools down. The green light will not go
off when battery pack cools, if fast charge mode is
desired, you must physically remove a hot battery
pack from the charger, let it cool, then place it back in
charger after it has cooled down.
Note: This situation only occurs when continuous use
of your ddil causes the batteries to become hot. It
does not occur under normal circumstances. Refer to
"CHARGING YOUR REDI DRILL-DRIVER"
for
normal recharging of batteries. If the charger does not
charge your battery pack under normal circum-
stances, return both the battery pack and charger to
your nearest Sears repair center for electrical check.
7
Advertisement
