Advertisement
RULES
FOR SAFE OPERATION
(Continued)
•
To i'educe dsk of damage to charger body and
cord, pull by charger body rather than cord when
disconnecting charger.
Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected
to damage or stress.
An.extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a dsk of fire and electric
shock. If extension cord must be used, make
sure:
a.
That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
b.
That extension cord is propedy wired and in
good electrical condition; and
c.
That wire size is large enough for AC
ampere rating of charger as specified
below:
Cord Length (Feet) 25'
50' 100'
150'
Cord Size (AWG)
16
16
16
14
Note: AWG = American Wire Gage
DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged,
have replaced immediately by a qualified
serviceman.
Do not operate charger if charger has received
a sharpblow, been dropped, pr otherwise
damaged in any way; take it to a qualified
serviceman.
Do not disassemble charger; take it to a
qualified serviceman when service or repair is
required. Incorrect rsessembly may result in a
dsk of electdc shock or fire.
To reduce risk of electdc shock, unplug charger
from outlet before attempting any maintenance
or cleaning. Turning off controls will not reduce
this dsk.
•
Do not use charger outdoors.
•
Disconnect charger from power supply when
not in use.
SAVE THESE INSTRUCTIONS. Refer to them
frequently and use them to instruct others who
may use this tool. If you loan someone this tool,
loan them these instructions also.
,_
Look for this symbol to point out important
safety precautions.
It means
attentiont!!
Your
safety
is involved.
Chuck Capacity
Motor
Charger Rating
No Load Speed
3/8 in.
12 Volts DC
120 Volts, 60 Hz, AC Only
0-600 RPM
Switch
Charge Rate
Maximum Torque
Variable Speed - Reversible
1 Hour
110 in. Ibs.
Your redi drill-driver has been shipped completely
assembled. Inspect it carefully to make sure no
breakage or damage has occurred during shipping. If
any parts are damaged or missing, contact your
nearest Sears Retail Store to obtain replacement parts
before attempting to operate drill-driver.
WARNING:
If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
5
Advertisement
