To Assemble Wheels; Assemble Rubber Feet; To Add Oil To Pump; Operation - Craftsman 919.195411 Owner's Manual

6.
Rotate each retaining clip
clockwise and press down until it
snaps into place over the handle.
}_*Jk_EE BELT 4
6.
If the handle has excessive
movement, it is improperly
installed. Check the following.
A. Are both tabs inside the
handle (Step #3)?
B. Does each clip pass through
both the saddle and handle
(Step #4)?
To Assemble Wheels
_lt will be necessary
to brace or support
one side of the air compressor
when installing the wheels because
the compressor will have a
tendency to tip.
1. Attach wheels with shoulder
bolts and nuts as shown.
2. Tighten securely. NOTE: The air
compressor will sit level if the
wheels are properly installed.
The wheels and
handle do not
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Assemble Rubber Feet
1. Attach rubber feet with the
screws, washers and nuts
provided as shown in figure
below.
2. Tighten securely.
Nut
Wheel
Shoulder
_ ;Ubbwer Foot Bolt
To Add Oil To Pump
_ Compressors are
shipped without oil
A small amount of oil may be
present in the pump upon receipt
of the air compressor. This is due
to plant testing and does not mean
the pump contains oil. Do not
attempt to operate this air
compressor without first adding oil
to the crankcase. Serious damage
can result from even limited
operation unless filled with oil and
broken in correctly. Make sure to
closely follow initial start-up
procedures.
_Use air compressor
oil only. Multi-
Viscosity motor oils, like lOW 30,
should not be used in an air
compressor. They leave carbon
deposits on critical components,
thus reducing performance and
compressor life.
NOTE: Use an air compressor oil
such as Sears item number 9-16426
or SAE-20 (API CG/CD heavy duty
motor oil. Under extreme winter
conditions use SAE-10 weight oil.
11_ENG D30090