Nortel AS 5300 Fundamentals page 56

Field
Supported Digital Relay
Methods
Add
Add All
Remove
Remove All
Up and Down
Assign RFC 2833 Payload
Type Dynamically
Specify Type
Restart Required
OK
Cancel
Users properties
The following figure shows an example of a Users Properties dialog box.
Copyright © 2008, Nortel Networks
- 56 -
Nortel MAS Console
Description
You can enable or disable the following supported
digital relay methods: INFO Digits and RFC2833.
Attention: Nortel recommends that you do not
disable all methods. If you disable all methods,
inband DTMF detection is enforced and system
capacity degrades.
Click Add to enable a digital relay method. From
the Available list, select a digital relay method, and
then click Add.
Click Add All to enable all digital relay methods.
From the Available list, select a digital relay
method, and then click Add All.
Click Remove to disable a digital relay method.
From the Enable list, select a digital relay method,
and then click Remove.
Click Remove All to disable all digital relay
methods. From the Enable list, select a digital relay
method, and then click Remove All.
Use the Up and Down buttons to change the order
of the enabled digital relay methods.
This check box is selected by default. Nortel
recommends that RFC 2833 payload type is
assigned dynamically. However, some clients
require a fixed payload type.
If you require a fixed payload type, clear the Assign
RFC 2833 Payload Type Dynamically check box,
and then in the Specify Type box, type the payload
type.
This is a read-only field. It indicates whether a
restart of the server is required if you modify the
trusted node host name or IP address. Values are
Yes and No. Yes indicates a platform restart is
required for the configuration change to take effect.
Click OK to close the dialog box.
Click Cancel to close the dialog box without saving
changes.
Nortel Media Application Server 6.0 for AS 5300
Fundamentals
NN44470-100 01.01 Standard
Release 6.0 03 June 2008