Assembly - NordicTrack E3000 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench
help identifying the assembly hardware, see the hardware drawings below.
Console Bolt (110)–4
Frame Bolt (31)–4
Upright Bolt (113)–4
1. Raise the end of the Frame (not shown) until the tread-
mill can be moved on the Front Wheels (66), and care-
fully roll the treadmill off the wood pallet.
Insert the Wire Harness (108) through the Upright Plate
(115).
With the help of a second person, hold the Upright (111)
and the Upright Plate (115) against the Frame Cover
(52). See the inset drawing and make sure that the
Upright and the Upright Plate are oriented as
shown. Attach the Upright and the Upright Plate with
four Upright Bolts (113) with two Star Washers (114).
Do not tighten the Upright Bolts yet.
and your own Phillips screwdriver
Handrail Bolt (90)–4
6
3/4" Tek Screw
(91)–4
Washer (116)–4
1
111
52
115
. For
Panel Screw
(101)–3
Star Washer
(114)–4
115
111
66
108
114
114
113