Craftsman INCREDI.PUL 316.794010 Operator's Manual page 5

ASSEMBLING THE BLOWER TUBE
I, lw'°"'"O o vo'se ous erson u n'' m oe*othe l
unit, shut the unit off before removing or installing the blower tubes.
Installing the Flex Tube
1. Place a hose clamp over the
end of the Flex Tube (Fig. 1).
2. Slide the end of the Flex
Tube with the clamp on it
over the elbow tube and
tighten the screw on the
hose clamp (Fig. 1).
Installing the Upper Blower
Tube
1. Place a hose clamp over the
other end of the Flex Tube
(Fig. 2).
2. Slide the end of the hose
with the clamp on it over the
top end of the upper blower
tube and tighten the screw
on the hose clamp (Fig. 2).
Installing the Lower Blower
Hose
Tube and Nozzle Clamp"
1. Insert the bump on the upper
blower tube into the bump
slot on the lower blower tube
(Fig. 3).
2. While holding the upper
blower tube, twist the lower upper
blower tube clockwise until it Blower _
locks into place (Fig. 3).
Tube "_¢ lr
3. Insert the bump on the lower
blower tube into the bump Bump_ _-_z_
slot on the nozzle (Fig. 4).
4. While holding the lower
blower tube, twist the nozzle
clockwise until it locks into
place (Fig. 4).
The completed blower tube
should look like Figure 7.
_1 WARNING: Toavoid
L.... I
I serious personal injury, Blower j
I make sure that
the
Tube"_l_U
J blower tubes are
J locked in place or
J f rm y nsta ed. Bump '_
Secure the Throttle Cables
Place a zip tie around the elbow
tube and the throttle cables, as
shown (Fig. 5). Tighten the zip tie,
making sure not to crimp the cables.
Nozzle
Fig. 1
Fig. 2
Bump
Fig. 3
Bump
/ Slot
€,
Fig. 4
Elbow Tube
Cables /f \_=- Zip Tie
Adjusting the Throttle Grip
1. Move the throttle grip to a
location on the upper blower
tube that provides the best
grip (Fig. 6).
2. Using a T-20 Torx®
screwdriver, tighten the two
screws at the bottom of the
throttle grip (Fig. 6).
Cables
Upper Blower Tube
Throttle Control
Lower Blower Tube
Nozzle
f_-_ Throttle
upper J centre'
B'T%r
T-20 Torx Screw
Fig. 6
Elbow Tube
Hose Clamp
Flex Tube
Hose Clamp
On/Off Switch
Cruise Control
Fig. 7
Fig. 5