Craftsman 139.53991 Owner's Manual page 36

To Add or Change a Keyless Entry PIN
NOTE: Your new Keyless Entry must be programmed to operate your garage door opener
USING THE "LEARN" BUTTON USING THE PREMIUM CONTROL CONSOLE
1 Press and release the "learn"
button on motor unit The learn
indicator light will glow steadily for
30 seconds
2 Within 30 seconds, enter a four
digit personal identification
number (PIN) of your choice on
the keypad Then press and hold
the ENTER button
3 Release the button when the
motor unit lights blink It has
learned the code If light bulbs are
not installed, two clicks will be
heard
To change an existing, known PIN
If the existing PIN is known, it may be changed by one
person without using a ladder
1 Press the four buttons for the present PIN, then
press and hold the # button
The opener light will blink twice Release the #
button
2 Press the new 4-digit PIN you have chosen, then
press Enter
The motor unit lights will blink once when the PIN has
been learned
Test by pressing the new PIN, then press Enter The
door should move
To set a temporary PIN
You may authorize access by visitors or service people
with a temporary 4-digit PIN After a programmed
number of hours or number of accesses, this temporary
PIN expires and will no longer open the door It can be
used to close the door even after it has expired To set
a temporary PIN:
1 Press the four buttons for your personal entry PIN
(not the last temporary PIN), then press and hold the
=_button
The opener light will blink three times Release the
button
36
NOTE: This method requires two people if the Keyless
Entry is already mounted outside the garage.
1.
2.
.
Enter a four digit personal
identification number (PIN) of your
choice on the keypad Then press
and hold ENTER
While holding the ENTER button,
press and hold the LIGHT button
on the Premium Control Console
Continue holding the ENTER and
LIGHT buttons while you press
the push bar on the Premium
Control Console (all three buttons
are held)
4.
Release buttons when the motor
unit lights blink It has learned the
code If light bulbs are not
installed, two clicks will be heard
2 Press the temporary 4-digit PIN you have chosen,
then press Enter
The opener light will blink four times
3 To set the number of hours this temporary PIN will
work, press the number of hours (up to 255), then
press 8
OR
3 To set the number of times this temporary PIN will
work, press the number of times (up to 255), then
press #
The opener light will blink once when the temporary PIN
has been learned
Test by pressing the four buttons for the temporary PIN,
then press Enter The door should move If the
temporary PIN was set to a certain number of openings,
remember that the test has used up one openingTo
clear the temporary password, repeat steps 1-3, setting
the number of hours or times to 0 in step 3