Craftsman 126.32563 Operator's Manual page 25

1. Place a combination square on the table
with the rule against the Fence and the heel
against the Blade. (Fig. R)
by loosening its fastening screw using a #2
Phillips screwdriver. Adjust as necsessary,
and then securely tighten the screw.
(Fig. R)
(Note for illustrative purposes only the Cutting
Head has been removed from this diagram)
2. If adjustment is necessary, loosen the four (4)
Fence adjustment screws using an Allen Key.
3. Re-position the Fence in its elongated
slots until alignment is achieved.
4. Securely tighten the socket head screws.
CUTTING HEAD TRAVEL
Cutting Head Downward Travel
Adjustment (Fig. S)
To prevent the blade from contacting any part
of the machine metal base the downward
travel of the Cutting Head can be adjusted.
Lower the Cutting Head and check for any
blade contact with the machine base.
If the downward travel of the Cutting Head
needs to be adjusted:
1. Loosen the Iocknut on the downward
travel stop screw.
2. Turn the adjusting screw out (counter-
clockwise) to decrease the downward travel
of the Cutting Head.
3. Turn the adjusting screw in (clockwise) to
increase the downward travel of the Cutting
Head.
4. Tighten the adjustment screw Iocknut
when satisfactory downward travel of the
Cutting Head is achieved.
(Fig. S)
Miter Angle Pointer Adjustment \
\
NOTE: There are dual miter angle scales
cast into the front of the machine base.
A small pointer indicates the angle selected ....
Set the rotary table to 0° Miter ensuring that
the 0° Positive Stop is engaged. Check that
the Miter pointer is in exact alignment with
the 0° index mark.
If necessary the pointer can be repositioned
25