Using Tcp/Ip Protocol; Installation Overview - Oki C9600hdn Network And Configuration Manual

Printing from Windows:

Using TCP/IP Protocol

Installation Overview

There are a number of options available when printing using TCP/IP for
Windows.
Windows Version
XP
2000
Me
98
NT 4.0
a.These functions are built into Windows and are displayed as
options when using the Add Printer Wizard.
Although there are some differences in configuration options between the
various Windows platforms, the procedure for printing using TCP/IP is the
same.
Step 1: Ensure that the TCP/IP protocol has been installed in Windows.
This can be confirmed by checking the network settings from
within the Control Panel. If TCP/IP has not been installed refer to
"Installing TCP/IP Protocol" on page 163.
Step 2: If not already done, a suitable IP address, Subnet Mask and
Gateway address should be configured.
The current addresses appear under "TCP/IP Configuration" on
the Self-Diagnostic test printout (see page 12). It is vital that the
IP address entered is unique and valid. Entering an incorrect IP
address may cause severe network problems. Please check the
address with the network administrator. To change the
addresses, see "Configuring the IP Address, Subnet Mask and
Gateway" on page 165.
Step 3: Configure Windows to print to the network printer.
Method
OKI LPR Utility
Microsoft LPR
Port 9100
a
IPP
OKI LPR Utility
OKI LPR Utility
Microsoft LPR
OkiLAN 8200e Network User's Guide
a
a
a
161