HP Surestore Disk Array 12h - And FC60 System Administrator Manual page 266

Using the ARM Command Line Utilities for Windows NT
Viewing the Disk Array General Configuration Settings
Parameter
Disable Remote Reset ENABLED Controls the bus reset behavior of the second controller
Secondary Controller
Offline
Very Early Busy
Queue Full Threshold
Maximum Queue Full
Threshold
Simplified Resiliency
Setting
266
Default
Setting
when a SCSI reset (reset signal, BDR or Reset Disk array
command) is received in the first controller. When this bit
is disabled, the second controller will assert the bus reset
signal to indicate that all outstanding requests were
cleared in response to the reset. When this bit is enabled,
the second controller will not assert the SCSI reset signal
to indicate the commands were cleared. Hosts that
cannot tolerate target bus resets should enable this
setting.
DISABLED Controls the behavior of the secondary controller with
respect to bus selection. When disabled, any secondary
controller present will respond to host selection. When
enabled, the secondary controller will remain off-line until
a failure of the primary controller is detected (at which
point it becomes primary). Only the primary controller will
go on-line.
DISABLED Controls the behavior of the disk array with respect to
SCSI bus selection during the early stages of the
initialization sequence (i.e., from about three seconds
after reset until about fifteen seconds prior to initialization
completion). When disabled, the disk array will ignore
SCSI bus selection until the late stages of initialization.
When enabled, the disk array will accept selection during
early initialization and will return BUSY status until the late
stages of initialization.
1952 Specifies the target queue depth beyond which the disk
array will return QUEUE FULL status to subsequent host
requests.
1952 Specifies the maximum supported value for the Queue
Full Threshold parameter. Attempts to set the QFT
parameter to values higher than the MQFT will fail with
CHECK CONDITION status and ILLEGAL REQUEST,
INVALID FIELD IN PARAMETER LIST sense indications.
Normal Determines the values of the following eight parameters.
This field regulates the mode of data resiliency that the
disk array will operate in. The "Normal" mode is set at the
factory when dual controllers are ordered with the array.
Description