Template 3, Uses 10Gbe Network Only; Template 4, Uses Two 1Gbe Networks - HP StoreOnce B6000 Series Planning And Preparation Manual

Backup system installation planning and preparation guide nl and checklists (chapter 5)

Hide thumbs Also See for StoreOnce B6000 Series:

Table of Contents

Figure 5 Template 2 cabling to customer's networks

1, 2, 3 and 4

Template 3, uses 10GbE network only

Template 3 supports users who have a 10GbE network only. The same network is used for data

and management.

The recommended IP address range is 17 in total: 1 for management and 16 contiguous for data.

NOTE:

When using a 10GbE network, you must provide the correct SFPs for your environment.

They are not supplied with the product.

Figure 6 Template 3 cabling to customer's networks

1 and 2

Template 4 supports users who have two 1GbE networks. One 1 GbE network is used for data;

the other is used for management. The gateway must be in the same sub-net as the network that

is being used to connect to remote sites. This is normally the data path sub-net, for example used

for remote/external site replication traffic.

The recommended IP address range is 25 in total: 16 contiguous on the data sub-net; 1 + 8

contiguous on the management sub-net.

bonded 1 GbE ports to customer's data and management network

bonded 10 GbE ports to customer's data and management network

Supported network configurations (templates)

Table of Contents