Creating A Port Group And Enabling Automatic Login Balancing Mode - HP StoreFabric SN6500B Administrator's Manual

3
Port Grouping policy
Managed Fabric Name Monitoring mode
When enabled, Managed Fabric Name Monitoring (MFNM) mode queries the fabric name at a
specific time period. If it detects an inconsistency, for example all the N_Ports within a port group
are not physically connected to the same physical or virtual fabric, it generates a RASLOG message.
In "default" mode, a message is logged into RASLOG. In "managed" mode, automatic failover is
disabled for all N_Ports within the N_Port group, and a message is logged into RASLOG about
multiple fabrics.
Enable or disable MFNM mode on a port group using the steps under
page 45 and
queries the fabric name once every 120 seconds. You can configure the monitoring timeout value
to something other than 120 seconds using the steps under
timeout value"

Creating a port group and enabling Automatic Login Balancing mode

1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --pgcreate command with the appropriate options to create a port group. In the
3. Enter the ag --pgshow command to verify the port group was created. A table containing a
Rebalancing F_Ports
To minimize disruption that could occur once F_Ports go offline or when additional N_Ports are
brought online, you can modify the default behavior of Automatic Login Balancing mode by
disabling or enabling rebalancing of F_Ports when F_Port offline or N_Port online events occur.
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the agautomapbalance --enable command with the appropriate options to enable
3. Enter the agautomapbalance --disable - all command with the appropriate options to disable
4. Enter the agautomapbalance --disable - all command with the appropriate options to disable
44
"Disabling MFNM mode"
on page 46.
following example, a port group named "FirstFabric" is created that includes N_Ports 1 and 3
and has Automatic Login Balancing (lb) enabled.
switch:admin> ag --pgcreate 3 "1;3" -n FirstFabric1 -m "lb"
Port Group 3 created successfully
port group with ID 3 and ports 1 and 3 should display.
automatic login redistribution of F_Ports. In the following example, rebalancing of F_Ports in
port group 1 in Access Gateway is enabled when an F_Port online event occurs.
switch:admin> agautomapbalance --enable -fport -pg 1
automatic login distribution of N_Ports for all port groups in the Access Gateway when an
N_Port online event occurs.
switch:admin> agautomapbalance --disable -nport -all
automatic login distribution of F_Ports for all port groups in the Access Gateway when an
F_Port online event occurs.
switch:admin> agautomapbalance --disable -fport -all
on page 45. In both default and managed mode, the system
"Setting the current MFNM mode
"Enabling MFNM mode"
Access Gateway Administrator's Guide
53-1002743-01
on